Making a sequin necklace

A while ago I saw this tutorial on Pinterest for making a sequin bangle. I really liked the look of all those sequins stacked up together and thought I’d try making a necklace using the same technique! Here is what I made:

sequin necklace DIY

I’m not going to post a detailed how-to here since I used very basic jewellery making techniques to make my necklaces, but do let me know if you want one!

The original blog post used cup sequins strung onto wire and shaped into a bangle shape. I didn’t realise she used cup sequins until after I had bought a load of flat sequins! (very cheap from a shop in Sham Shui Po) Oops. I think that the cup sequins stack together better than the flat sequins, but I still like the look that I managed to achieve.

mint green and white sequin necklace

Another difference to the original tutorial is that I strung the sequins on flexible multi-strand beading wire, rather than standard wire, to allow the necklace to drape well. I started out by stringing the sequins one at a time (VERY slow!) but quickly got bored. I realised that a much quicker way was to stack a bunch of sequins between my forefinger and thumb and then roll them gently to line them all up so you can then just thread your wire through the middle.

I was originally thinking of putting a bead on each end of my sequin string, but then I thought that a spiral copper cone would be quite fun! I’ve not made one before but I’ve seen various tutorials that use a pencil tip to create the cone shape. I wasn’t sure whether to start my cone at the tip or the bottom but I found it easier to make the cone shape from the tip down, by using pliers to hold the end of the wire cone against the tip of the mechanical pencil I was using. I had a few goes, and used the best two on my necklace. I have to admit that it’s very difficult to make a nice even, tightly curled cone! It’s certainly made me realise how much work I’m going to have to put in if I want to be really good at wire work…

sequin necklace with copper wire cones

One thing to note is that the base of the cone is slightly angled because there is a wire sticking out, and this makes your cone angled against the sequins. Maybe you could trim the end of the wire on your cone at an angle to reduce this.

Also, your cone won’t naturally stay central because it has a big open end. To get around this you could either make the end of the cone slightly bigger than your sequins, so the cone fits over the end of your sequin string, or thread a small bead onto your beading wire before you thread the cone on so that the bead fits inside your cone (and is hidden). I did mine the second way, using a large seed bead.

I was really pleased with how the cones look on the necklace!

silver and copper stacked sequin necklace

Anyway, I was having so much fun that I made another sequin necklace! This time I strung my sequins onto a short, straight piece of 0.6mm (22ga) wire.

mini stack sequin necklace

Again, I wanted to do something with each end of the sequin stack. This time I made a little flat copper wire spiral, which was actually really easy to do. Just make a small loop with some round nose pliers, and then continue winding your wire around the loop, holding the spiral flat with pliers as you go.

sequin necklace with copper wire spiral

I finished off each end of the wire with a wire-wrapped loop, threading the loop through the end of a piece of chain before wrapping the wire round. Again, because the wire wrapped loop finishes with a piece of wire sticking out, it makes the end of the sequins slightly angled. You could trim the end of the wire at an angle to minimise this, although it would be quite fiddly.

I think I prefer the other necklace, but the little cylinder-type pendant is quite nice!

green and white sequin stack pendant

What do you think? Do you have a favourite? Do you like the look of the stacked sequins? Do let me know if you have a go at this yourself!

Thanks for reading!

Rachel

newsletter signup banner

Advertisements